interference fit การใช้

• Dr . Lehman's technique uses interference fit screws instead of bone tunnels.
• The tire is primarily held in place by its interference fit.
• Interference fit generally ranges from minimum to maximum interference.
• Some can, but need special equipment to insert the oversized bushing for an interference fit.
• Because the brake blocks apply directly on the tire, it is heated up, relaxing the interference fit.
• Interference fit is obtained if the difference between the hole and shaft sizes is negative before assembly.
• This interference fits a pattern elsewhere.
• When the liner then warms up, it expands, and the resulting interference fit holds it tightly in place.
• The shoulder on the outside and the retaining ring also keep the tire in place if the interference fit is lost.
• The head tube can stretch, allowing a headset cup, which is supposed to be a tight interference fit, to become loose in the tube.
• Scoring of the wall of the hole and the absence of an interference fit left the inner lower boom vulnerable to developing fatigue cracks at Station 143.
• The magnitude of the difference ( negative ) between the maximum size of the hole and the minimum size of the shaft in an interference fit before assembly.
• This broaching action scored the wall of the hole and left its diameter slightly oversize so the bush was not an interference fit anywhere except at its flared end.
• The sleeve, keyed to the neck to prevent creeping during operation, produces a slight interference fit on the roll neck by means of the push-up force used to mount the bearing on the roll.
• The outer cup covering the ratchet pawls and bearings is pressed into place at the factory, secured by interference fit, leveraging the same inner threads of the shell into which the cassette lockring normally screws.
• A dowel pin may have a smaller diameter than its hole so that it freely slips in, or a larger diameter so that it must be pressed into its hole ( an interference fit ).
• Unlike other woodwind instruments, in most wooden piccolos the tenon joint connecting the head to the body has two interference fit points which surround both the cork and metal side of the piccolo body joint.
• A class called " interference fit " may even provide for negative allowances, where the PD of the screw is greater than the PD of the nut by at least the amount of the allowance.
• The best fits are generally attained by selecting slightly oversized parts ( or altering stock parts to form an interference fit ) and then lapping the mating surfaces to attain the desired fit ( clearance ).
• Slightly undersized holes incorporated into the inner surface enclose the bushings, which have truncated cone cross-section and are slightly undercut, forming a one-way interference fit when pressed into the generally softer and more elastic scale material.